Nuvico HDoCS DT_E/P Instruction Manual page 12

Rear Panels(DT-E)
No. Item
1 VIDEO IN
2 HDMI
3 VGA
4 AUDIO OUT
5 AUDIO IN
6 Network Interface
7 USB Port
8 GND
9 Power Supply
To connect PTZ to the DVR:
2.3.3 Disconnect pluggable block from the RS-485 terminal block.
2.3.4 Press and hold the orange part of the pluggable block; insert signal cables into slots and release
the orange part. Ensure signal cables are in tight.
2.3.5 Connect A+ on PTZ to T+ on terminal block and B- on controller to T- on terminal block.
Fasten stop screws.
2.3.6 Connect pluggable block back into terminal block.
To connect a controller to the DVR:
4 Disconnect pluggable block from the KB terminal block.
5 Press and hold the orange part of the pluggable block; insert signal cables into slots and release the orange
part. Ensure signal cables are in tight.
6 Connect Ta on controller to D+ on terminal block and Tb on controller to D- on terminal block. Fasten stop
screws.
7 Connect pluggable block back into terminal block.
NOTE
Make sure both the controller and DVR are grounded.
Table 1. 9 Description of Rear Panel
Description
BNC interface for TVI and analog video input.
HDMI video output connector.
DB15 connector for VGA output. Display local video output and menu.
RCA connector.
RCA connector.
Connector for network
Universal Serial Bus (USB) port for additional devices.
Ground
DC 12V power supply.
pins of PTZ receiver respectively.
D+, D- pin of the next DVR.
12