Configuring Ptz Settings - Nuvico HDoCS DT_E/P Instruction Manual

Table of Contents

4.1 Configuring PTZ Settings

Follow the procedure to set the parameters for PTZ. The configuring of the PTZ parameters should be done

before you control the PTZ camera.

Steps:

1. Enter the PTZ Settings interface.

Menu >Camera> PTZ

2. Choose the camera for PTZ setting in the Camera dropdown list.

3. Click the RS-485 Settings button to set the RS-485 parameters.

4. Enter the parameters of the PTZ camera.

NOTE

All the parameters should be exactly the same as the PTZ camera parameters.

For the Coaxitron camera/dome connected, you can select the PTZ protocol to PELCO-C (Coaxitron).

Make sure the protocol selected here is supported by the connected camera/dome.

When the Coaxitron protocol is selected, all the other parameters like the baud rate, data bit, stop bit, parity and

flow control are not configurable.

1. Click Apply button to save the settings.

Table of Contents