Setting The Ip Address For Both Blades - LifeSize Multipoint 230 Installation Manual

Setting the IP Address for Both Blades

S IP
ETTING THE
A
DDRESS FOR
B B
OTH LADES
#!
16 LifeSize Multipoint 230 Installation Guide
You use the serial port on the LifeSize Multipoint front panel to assign a new IP
address to your LifeSize Multipoint. You must assign the IP address before you
connect the LifeSize Multipoint to the network.
Before You Begin
Gather these items to assign an IP address to the LifeSize Multipoint:
Dedicated IP address for the two Media Blades
"
Dedicated subnet mask for the LifeSize Multipoint
"
IP address of the default router the LifeSize Multipoint uses to
"
communicate over the network
PC with available serial port and terminal emulator software installed
"
Serial cable
"
Procedure
Connect the serial cable from the PC terminal to the serial port on the
1
front panel of the upper Media Blade.
Connect the power cable.
2
Start the terminal emulation application on the PC.
3
Set the communication settings in the terminal emulation application on
4
the PC as follows:
Baud rate: 9600
$
Data bits: 8
$
Parity: None
$
Stop bits: 1
$
Flow control: None
$
Turn on the power to the LifeSize Multipoint.
5
A log of the auto-boot events and a VxWorks banner scrolls across the
computer monitor.