Operation And Lcp; Operating Modes - Danfoss vlt soft starter mcd 500 Operating Manual

Operation

6.2 Operation and LCP

6.2.1 Operating Modes

In hand-on mode:
•
To soft start the motor, press [Hand On] on the
LCP.
•
To stop the motor, press [Off] on the LCP.
•
To reset a trip on the soft starter, press [Reset] on
the LCP.
•
To stop the motor with a coast to stop, regardless
of the setting of parameter 1-10 Stop mode, press
[Off] and [Reset] at the same time. The soft
starter removes power from the motor and opens
6 6
the main contactor, and then the motor coasts to
stop.
In auto-on mode:
•
To soft start the motor, activate the Start remote
input.
•
To stop the motor, activate the Stop remote input.
•
To reset a trip on the soft starter, activate the
Reset remote input.
NOTICE
Brake and jog functions operate only with in-line
connected motors (see chapter 4.3.3 Inside Delta Instal-
lation).
52
®
VLT Soft Starter MCD 500
6.2.2 The LCP
1
2
3
4
5
Illustration 6.1 LCP Layout
Danfoss A/S © 05/2016 All rights reserved.
®
4-line display for status and programming details.
Display control keys:
[Status]: Returns to the status displays.
[Quick Menu]: Opens the Quick Menu.
[Main Menu]: Opens the Main Menu.
[Alarm Log]: Opens the Alarm Log.
Menu navigation keys:
[Back]: Exits the menu or parameter, or cancels a
parameter change.
[OK]: Enters a menu or parameter, or saves a
parameter change.
▲ ▼
[ ]/[ ]:
Scroll to the next or previous menu or
parameter.
Change the setting of the current
parameter.
Scroll through the status screens.
Soft starter local control keys:
[Hand On]: Starts the motor and enters local
control mode.
[Off]: Stops the motor (only active in hand-on
mode).
[Auto On]: Sets the soft starter to auto-on mode.
[Reset]: Resets a trip (hand-on mode only).
Remote input status indicators.
1
2
3
4
5
MG17K602