Mercedes-Benz B-Class F-CELL Operator's Manual page 342

245_AKB; 1; 73, en-US
d2ureepe,
Replacing bulbs
340
G
Warning!
Batteries contain poisonous and corrosive
substances. Therefore, keep the batteries out
of reach of children.
If a battery is swallowed, seek medical help
immediately.
G
Warning!
SmartKey batteries contain perchlorate
material, which may require special handling
and regard for the environment. Check with
your local government's disposal guidelines.
California residents, see www.dtsc.ca.gov/
HazardousWaste/Perchlorate/
index.cfm.
Batteries contain materials that can harm the
environment if disposed of improperly.
Recycling of batteries is the preferred method
of disposal. Many states require sellers of
batteries to accept old batteries for recycling.
When inserting the batteries, make sure they
are clean and free of lint.
When replacing batteries, always replace
both batteries.
i The required replacement batteries are
available at any authorized F-CELL Service
Center.
Replacement batteries: Lithium, type
CR 2025 or equivalent.
X
Remove the mechanical key from the
SmartKey ( Y page 338).
2009-09-03T15:03:17+02:00 - Seite 340
Version: 2.11.8.1
X
Press mechanical key ; into the SmartKey
opening until battery compartment
cover : opens. Do not keep the cover
shut.
X
Remove the battery compartment cover.
X
Pat the SmartKey against the palm of your
hand until battery = falls out.
X
Insert the new battery with the positive
terminal (+) facing up. Use a lint-free cloth.
X
Insert the tabs of the battery compartment
cover into the housing and press the cover
closed.
X
Slide mechanical key : back into the
SmartKey.
X
Check the operation of the SmartKey.
Replacing bulbs
Safety notes
Safe vehicle operation depends on proper
exterior lighting and signaling to a large
degree.
Correct headlamp adjustment is extremely
important. Have headlamps checked and
readjusted at regular intervals and when a
bulb has been replaced. Contact an
authorized F-CELL Service Center for
headlamp adjustment.
G
Warning!
Bulbs and bulb sockets can be very hot. Allow
the lamp to cool down before changing a bulb.