Mercedes-Benz B-Class F-CELL Operator's Manual page 174

245_AKB; 1; 73, en-US
d2ureepe,
Video
172
Notes on Storage Media
i
When playing copied discs, problems may
occur with the playback. A wide variety of
disc-writing software and writers are
available. Due to this variety we cannot
guarantee that the system will be able to
play discs that you have written/copied
yourself.
! Do not affix stickers or labels to the discs,
as they could peel off and damage
COMAND. Stickers can cause the disc to
bend, which can result in read errors and
disc recognition problems.
! COMAND is designed to hold discs which
comply with the EN 60908 standard. You
can therefore only use discs with a
maximum thickness of 1.3 mm.
If you insert thicker discs, e.g. those that
contain data on both sides (DVD on one
side and audio data on the other), they
cannot be ejected and can damage
COMAND.
Do not use discs with a diameter of 8 cm,
even with an adapter. Only use round discs
with a diameter of 12 cm.
Notes on the Care of Discs
Only hold discs by the edge.
R
Handle discs with care in order to prevent
R
malfunctions during playback.
Avoid scratching, leaving fingerprints and
R
dust on the discs.
Clean the discs occasionally with a
R
commercially available cleaning cloth.
Always wipe in a straight line from the
inside outwards, never in a circular motion.
The discs must only be labeled using pens
R
specially designed for this purpose.
After use, replace the discs into the sleeve.
R
Protect the discs from heat and direct
R
sunlight.
2009-09-03T15:03:17+02:00 - Seite 172
Version: 2.11.8.1
DVD Playback Conditions
Some DVDs may not comply with the NTSC
or PAL TV playback standards. Sound, picture
and other playback problems may occur
when you play such DVDs.
As standard, COMAND can play video DVDs
which meet the following criteria:
Region code 1 or region code 0 (no region
R
code)
i
With a video DVD having another region
code, a corresponding message will be
displayed.
PAL or NTSC TV standard
R
Information on this can usually be found
either on the DVD itself or on the DVD sleeve.
i
The factory setting for COMAND is region
code 1. An authorized F-CELL Service
Center can change this setting. This will
enable you to play video DVDs with other
region codes, provided that they have been
made to the PAL or NTSC TV standard.
Functional Restrictions
It may be the case that some functions or
actions may not be possible at certain times,
or may not be possible in general, depending
on the DVD.
When you activate such functions or actions,
this is indicated by the 7 in the display.
Loading a DVD
X
Proceed as described in the "Loading CDs
and DVDs" section ( Y
Ejecting a DVD
X
Proceed as described in the "Ejecting CDs
and DVDs" section ( Y
page 157).
page 159).