Mercedes-Benz B-Class F-CELL Operator's Manual page 230

245_AKB; 1; 73, en-US
d2ureepe,
Power windows
228
and "Convenience closing feature"
( Y page 229).
i After switching off the ignition or
removing the SmartKey from the starter
switch, you can operate the door windows
until you open the driver's or front
passenger door. If no door was opened you
can operate the door windows for up to
5 minutes.
Left front door window
:
Right front door window
;
Left rear door window
=
Right rear door window
?
Override switch
A
X
Switch on the ignition.
X
Opening/closing: Press or pull and hold
switch : to ? to the resistance point.
The corresponding door window moves
downward or upward until you release the
switch.
X
Express operation: Press or pull
switch : to ? past the resistance point
and release.
The corresponding door window opens or
closes completely.
X
Stopping during express operation:
Press or pull the respective switch again.
2009-09-03T15:03:17+02:00 - Seite 228
Version: 2.11.8.1
Closing when a door window is blocked
G
Warning!
Make sure that nobody can become trapped
and be seriously or even fatally injured when
closing a door window with greater force or
without automatic reversal function.
If the upward movement of a door window is
blocked during the closing procedure, the
door window will stop and open slightly.
X
Immediately after the door window has
stopped because it was blocked, pull and
hold the respective switch upward until the
door window is fully closed.
The door window closes with greater force.
If the door window is blocked again and opens
slightly:
X
Immediately after the door window was
blocked, pull and hold the respective
switch upward until the door window is fully
closed.
The door window closes without automatic
reversal function.
G
Warning!
Pulling and holding the switch to close the
door window immediately after it had been
blocked two times will cause the door window
to close without any reversal function for as
long as you hold the switch.
Synchronizing door windows
The door windows must be synchronized after
the battery has been disconnected or if the
door windows cannot be fully closed (express
operation).
Each door window must be synchronized
separately.
X
Close all doors.
X
Switch on the ignition.
X
Pull and hold switch :, ;, = or ? until
the respective door window is closed.
The door window opens again slightly.