Mercedes-Benz B-Class F-CELL Operator's Manual page 100

245_AKB; 1; 73, en-US
d2ureepe,
COMAND navigation system (Introduction)
98
Deleting a Block Area
X
To select the area you want to delete:
Press 9 or :.
X
Select Options£Delete.
You will be prompted to confirm that you
wish to delete the block area.
X
Select Yes or No.
If you select Yes COMAND deletes the
entry. A message will be displayed.
Saving an Off-road Route
If this function is switched on, an Off-road
route is recorded and stored.
i The recording function works only if the
vehicle is located in an area away from
digitized roads.
Switching the Function On/Off
X
Show the menu system, if necessary
( Y page 93).
X
Select Navi£Save Off-road Route.
X
Select Save Off-road Route in the
submenu.
Depending on the previous state, switch
the option on Ç or off c.
Displaying Memory Usage
i When the memory is 90% full, you see a
corresponding message. When the
memory is full, the function is no longer
available and a message appears.
X
To confirm the message: Press 9.
2009-09-03T15:03:17+02:00 - Seite 98
Version: 2.11.8.1
i In order to be able to continue using the
"Save off-road route" function, you should
delete the route memory afterwards.
X
Show the menu system, if necessary
( Y page 93).
X
Select Navi£Save Off-road Route
£Off-road Route Memory.
A bar shows the memory usage as a
percentage.
Deleting the Route Memory
X
Show the menu system, if necessary
( Y page 93).
X
Select Navi£Save Off-road Route
£Delete Off-road Route Memory.
A query appears asking whether the memory
should be deleted.
X
Select Yes or No.
If you select Yes, the memory is deleted.
Information on Map
You can have map information displayed at
the bottom edge of the screen.
X
To set: Display menu system if applicable
( Y page 93).
X
Select Navi£Information On Map.