Mercedes-Benz B-Class F-CELL Operator's Manual page 180

245_AKB; 1; 73, en-US
d2ureepe,
COMAND Voice Control (Overview)
178
conversation while driving. As such, for safety
reasons, we encourage the driver to stop the
vehicle in a safe place before answering or
placing a phone call.
For safety reasons, you should only select a
destination when the vehicle is stationary.
While the navigation system provides
directional assistance, the driver must remain
focused on safe driving behavior, especially
pay attention to traffic and street signs, and
should utilize the system's audio cues while
driving.
The navigation system does not supply any
information on stop signs, yield signs, traffic
regulations or traffic safety rules. Their
observance always remains in the driver's
personal responsibility. DVD maps do not
cover all areas nor all routes within an area.
Traffic regulations always have priority over
any route recommendations given.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximately
14 m) every second.
G
Warning
Navigation announcements are intended to
direct you while driving without diverting your
attention from the road and driving.
Please always use this feature instead of
consulting the map display for directions.
Consulting the symbols or map display for
directions may cause you to divert your
attention from driving and increase your risk
of an accident.
G
Warning!
Please do not use the Voice Control System
in an emergency, as the tone of your voice
may change in a stressful situation. This could
cause a delay in completing your phone call
in a timely manner. This could distract you in
an emergency situation and cause you to be
involved in an accident.
2009-09-03T15:03:17+02:00 - Seite 178
Version: 2.11.8.1
Symbols Only Used in this Chapter
The following symbols indicate:
s that you have to say something
t that there is a voice output from the
voice control
u that the system shows information on
the display.
Usage
You can use the voice control system to
operate the following systems:
Phone
R
Navigation
R
Address book
R
Audio (radio, DVD changer, memory card,
R
music register)
Say the commands without pausing between
individual words. If you enter a command that
does not exist or is incorrect, the voice
control system asks you for a new command
with "Please repeat" or "Please repeat your
entry!". The voice control confirms important
commands to you and gives you instructions
in the event of incorrect entries.
Command Types
Voice control distinguishes between the
following types of command:
Global commands:
R
These are commands which can be called
up at any time (e.g. help or phone
commands).
Local commands:
R
These are commands which are only
available for the active application (e.g.
"Enter Street" during navigation).
Active Application
The local commands refer to the application
currently shown on the display and to the
audio source you are currently listening to.