6-4 ADF Assembly
1. Before you remove the ADF assembly, you
should remove:
- Rear cover (see page 6-3).
- Scanner assembly (see page 6-4).
2. Remove the five screws securing the platen
cover and unlatch the ADF assembly by pushing
the part hooked the platen cover using a sharp
tool.
WorkCentre Pro 412
Launch Issue
3. Pull the ADF assembly upward and remove it.
4. Remove two screws and take out the ADF motor
assembly.
Platen Cover Ass'y
August 2001
Disassembly and Reassembly
Platen Cover Ass'y
Cover Side L
ADF Motor Ass'y
6-5