Table of Contents
Advertisement
Remote-controlled Functions
4.2
Remote-programmable Call Forwarding
Configuring the Function
Z
(reserved tel. no.)
line seizure code, e.g.
Deleting the Function
Z
(reserved tel. no.)
Using the telephone number reserved in the OpenCom 100 / Aastra 800 for
remote control, you can configure or delete call forwarding "Immediate" for your
own telephone number from a remote location. This remotely-programmed for-
warding overwrites any other existing call forwarding. Call forwarding "On Busy"
and "After Delay" are not affected. Incorrect or non-existent telephone numbers
are rejected. Your authorisation is checked in the same way as for forwarding
within the OpenCom 100 / Aastra 800.
A correct entry is confirmed with a positive acknowledgement signal, provided
the system administrator has not deactivated this function (in the Configurator,
Telephony: Settings menu). The external call is subsequently ended.
4.3
Remote-programmable Voicebox Configuration
and Query
If the system administrator has configured remote query authorisation for your
voicebox, you can query and configure your voicebox from an external telephone:
■
Using the OpenVoice telephone number (this number is included in the
incoming call distribution) ...
you dial the MSN or the system number assigned by the system administrator
to the OpenVoice internal number.
■
Using your own telephone number (this number is included in the incoming
call distribution, and you have activated call forwarding for this telephone to
the voicebox) ...
Z
(system PIN)
Z
)
(destination tel. no.)
Z
(system PIN)
Note: The procedure is aborted if there is a pause of longer
than 60 seconds between the entry of two digits. With this
duration, remote-controlled functions using GSM cell phones
can also be realised.
Remote-programmable Call Forwarding
Z
(your internal tel. no.)
Z
(your internal tel. no.)
(trunk
77
Advertisement
Table of Contents
