Table of Contents
Advertisement
Team Functions
3.2.2 MenuCard "Prog. team key"
Press and hold down the team key
1ƒModify text
of your telephone. To change the text, press
the
key and enter new text, if required. Press
Save
. If you delete the text, only the key's telephone number will be displayed.
2ƒCall signalling
Opticalƒ&ƒacoustic
Acoustic after delay
select
your telephone is to ring.
3ƒCall protect
only, or for external calls only. If call protection has been activated, this team key
will only indicate calls by means of a visual signal, even if they are made from a
direct-call key.
4ƒRing tone
: You can set the
1ƒExternal calls
incoming calls (
4ƒDoor call
) for each trunk key. Proceed as described in the section "2 Ring
Tone" on page 89.
5ƒCall wait. prot.
number of this team key are not signalled by a call waiting tone (but at the team
keys of other terminals unless a call waiting protection was programmed there).
3.2.3 MenuCard "Prog. busy key"
Press and hold the busy key
1ƒModify text
of your telephone. To change the text, press
the
key and enter new text, if required. Press
Save
. If you delete the text without entering any new text, only the key's tele-
phone number will be displayed.
74
: The text currently assigned to the key is shown on the display
: Determine whether call signalling to this key is to be
Opticalƒonly
,
, specify the number of seconds after which
: Switch call protection
Volume
: While you are making a call, other calls for the telephone
down, then select ...
: The text currently assigned to the key is shown on the display
for a moment, then select ...
. Delete the existing text with
Acousticƒafter delay
or
On
Off
or
for all calls, for internal calls
Melody
and
for different types of
2ƒInternal calls
,
. Delete the existing text with
Programming the Call Keys
and confirm this with
. If you
3ƒVIP call
,
and confirm this with
,
Advertisement
Table of Contents
