Configuring Secure Mac Addresses - HP MSR Series Configuration Manual

•
disableport-temporarily—Disables the port for a period of time. The period can be configured
with the port-security timer disableport command.
To configure the intrusion protection feature:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Configure the intrusion
protection feature.
4. Return to system view.
5. (Optional.) Set the silence
timeout period during which
a port remains disabled.
NOTE:
On a port operating in either macAddressElseUserLoginSecure mode or
macAddressElseUserLoginSecureExt mode, intrusion protection is triggered only after both MAC
authentication and 802.1X authentication fail for the same frame.

Configuring secure MAC addresses

Secure MAC addresses are configured or learned in autoLearn mode. If the secure MAC addresses
are saved, they can survive a device reboot. You can bind a secure MAC address only to one port in
a VLAN.
Secure MAC addresses include static, sticky, and dynamic secure MAC addresses.
Table 9 Comparison of static, sticky, and dynamic secure MAC addresses
Type Address sources
Manually added (by using
the port-security
Static mac-address security
command without the
sticky keyword).
Command
system-view
interface interface-type
interface-number
port-security intrusion-mode
{ blockmac | disableport |
disableport-temporarily }
quit
port-security timer disableport
time-value
Aging mechanism
Not available.
The static secure MAC addresses
never age out unless you perform any
of the following tasks:
•
Manually remove these MAC
addresses.
•
Change the port security mode.
•
Disable the port security feature.
209
Remarks
N/A
N/A
By default, intrusion protection is
disabled.
N/A
By default, the port silence
timeout is 20 seconds.
Can be saved and
survive a device
reboot?
Yes.