HP MSR Series Configuration Manual page 181

Authorization : Strict checking
ACL
IPv4:
Portal status: Enabled
Authentication type: Direct
Portal Web server: newpt
Authentication domain: Not configured
Pre-auth IP pool: Not configured
BAS-IP: 2.2.2.1
User Detection:
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
Pre-auth IP pool: Not configured
BAS-IPv6: Not configured
User detection: Not configured
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
A user can perform portal authentication by using the HPE iNode client or through Web page. Before
passing the authentication,
http://192.168.0.111:8080/portal. All Web requests from the user will be redirected to the
authentication page. After passing the authentication, the user can access Internet resources.
# After the user passes authentication, use the following command to display information about the
portal user.
[Router] display portal user interface gigabitethernet 2/0/2
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
VPN instance: N/A
MAC
0015-e9a6-7cfe
Authorization information:
: Disabled
Not configured
Server name
--
Mask
Mask
Server name
--
the user
IP
2.2.2.2
166
can access only
VLAN Interface
-- GigabitEthernet2/0/2
Action
--
Action
--
Prefix length
Prefix length
the authentication page