Configuring Cross-Subnet Portal Authentication - HP MSR Series Configuration Manual

IP address
Destination authenticate subnet:
IP address
A user can perform portal authentication by using the HPE iNode client or through Web page. Before
passing the
http://192.168.0.111:8080/portal. All Web requests from the user will be redirected to the
authentication page. After passing the authentication, the user can access Internet resources.
# After the user passes authentication, use the following command to display information about the
portal user.
[Router] display portal user interface gigabitethernet 2/0/2
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
VPN instance: N/A
MAC
0015-e9a6-7cfe
Authorization information:
DHCP IP pool: N/A
Session group profile: N/A
ACL: N/A
CAR: N/A

Configuring cross-subnet portal authentication

Network requirements
As shown in
Router B. A portal server acts as both a portal authentication server and a portal Web server. A
RADIUS server acts as the authentication/accounting server.
Configure Router A for cross-subnet portal authentication. Before passing the authentication, the
host can access only the portal server. After passing the authentication, the user can access Internet
resources.
Figure 63 Network diagram
authentication, the
IP
20.20.20.2
Figure 63, Router A supports portal authentication. The host accesses Router A through
user can access
VLAN Interface
-- GigabitEthernet2/0/2
170
Prefix length
Prefix length
only the authentication page