HP MSR Series Configuration Manual page 41

The device stops detecting the status of the RADIUS server when one of the following operations is
performed:
•
The RADIUS server is removed from the RADIUS scheme.
•
The test profile configuration is removed for the RADIUS server in RADIUS scheme view.
•
The test profile is deleted.
•
The RADIUS server is manually set to the blocked state.
•
The RADIUS scheme is deleted.
To configure a test profile for RADIUS server status detection:
Step
1. Enter system view.
2. Configure a test profile for
detecting the status of
RADIUS authentication
servers.
Creating a RADIUS scheme
Create a RADIUS scheme before performing any other RADIUS configurations. You can configure a
maximum of 16 RADIUS schemes. A RADIUS scheme can be used by multiple ISP domains.
To create a RADIUS scheme:
Step
1. Enter system view.
2. Create a RADIUS scheme
and enter RADIUS scheme
view.
Specifying the RADIUS authentication servers
A RADIUS authentication server completes authentication and authorization together, because
authorization information is piggybacked in authentication responses sent to RADIUS clients.
You can specify one primary authentication server and a maximum of 16 secondary authentication
servers for a RADIUS scheme. When the primary server is not available, the device searches for the
secondary servers in the order they are configured. The first secondary server in active state is used
for communication.
If redundancy is not required, specify only the primary server. A RADIUS authentication server can
function as the primary authentication server for one scheme and a secondary authentication server
for another scheme at the same time.
To specify RADIUS authentication servers for a RADIUS scheme:
Step
1. Enter system view.
2. Enter RADIUS scheme
view.
Command
system-view
radius-server test-profile
profile-name username name
[ interval interval ]
Command
system-view
radius scheme
radius-scheme-name
Command
system-view
radius scheme radius-scheme-name
26
Remarks
N/A
By default, no test profile is
created on the device to detect the
status of RADIUS servers.
You can configure multiple test
profiles by executing this
command multiple times.
Remarks
N/A
By default, no RADIUS scheme is
defined.
Remarks
N/A
N/A