HP MSR Series Configuration Manual page 229

Configuration procedure
# Enable port security.
<Device> system-view
[Device] port-security enable
# Set the secure MAC aging timer to 30 minutes.
[Device] port-security timer autolearn aging 30
# Set port security's limit on the number of secure MAC addresses to 64 on port GigabitEthernet
2/0/1.
[Device] interface gigabitethernet 2/0/1
[Device-GigabitEthernet2/0/1] port-security max-mac-count 64
# Set the port security mode to autoLearn.
[Device-GigabitEthernet2/0/1] port-security port-mode autolearn
# Configure the port to be silent for 30 seconds after the intrusion protection feature is triggered.
[Device-GigabitEthernet2/0/1] port-security intrusion-mode disableport-temporarily
[Device-GigabitEthernet2/0/1] quit
[Device] port-security timer disableport 30
Verifying the configuration
# Verify the port security configuration.
[Device] display port-security interface gigabitethernet 2/0/1
Port security parameters:
Port security
AutoLearn aging time
Disableport timeout
MAC move
Authorization fail
OUI value list
GigabitEthernet2/0/1 is link-up
Port mode
NeedToKnow mode
Intrusion protection mode
Security MAC address attribute
Learning mode
Aging type
Max secure MAC addresses
Current secure MAC addresses
Authorization
The port allows for MAC address learning, and you can view the number of learned MAC addresses
in the Current secure MAC addresses field.
# Display additional information about the learned MAC addresses.
[Device] interface gigabitethernet 2/0/1
[Device-GigabitEthernet2/0/1] display this
#
interface GigabitEthernet2/0/1
port-security max-mac-count 64
port-security port-mode autolearn
: Enabled
: 30 min
: 30 s
: Denied
: Online
:
: autoLearn
: Disabled
: DisablePortTemporarily
: Sticky
: Periodical
: 64
: 5
: Permitted
214