Displaying And Maintaining Session Management - HP MSR Series Configuration Manual

•
Traffic-based logging—The device outputs a session log when the traffic amount of a session
reaches a threshold. After outputting a session log, the device resets the traffic counter for the
session. The traffic-based thresholds can be byte-based and packet-based. If you set both
thresholds, the last configuration takes effect.
If you set both time-based and traffic-based logging, the device outputs a session log when
whichever is reached. After outputting a session log, the device resets the traffic counter and restarts
the interval for the session.
If you enable session logging but specify neither the traffic-based nor the time-based type, the device
outputs a session log when a session entry is created or removed.
To configure session logging:
Step
1. Enter system view.
2. (Optional.) Set a
time-based logging
type.
3. (Optional.) Set a
traffic-based logging
type.
4. Enter interface view.
5. Enable session
logging.

Displaying and maintaining session management

Execute display commands in any view and reset commands in user view.
Task
Display the aging time for sessions of
different application layer protocols.
Display the aging time for sessions in
different protocol states.
Display IPv4 session table entries
(centralized devices in standalone mode).
Display IPv4 session table entries
(distributed devices in standalone
mode/centralized devices in IRF mode).
Command
system-view
session log time-active time-value
•
Set the packet-based threshold:
session log packets-active
packets-value
•
Set the byte-based threshold:
session log bytes-active
bytes-value
interface interface-type interface-number
session log enable { ipv4 | ipv6 } [ acl
acl-number ] { inbound | outbound }
Command
display session aging-time application
display session aging-time state
display session table ipv4 [ source-ip start-source-ip
[ end-source-ip ] ] [ destination-ip start-destination-ip
[ end-destination-ip ] ] [ protocol { dccp | icmp | raw-ip | sctp
| tcp | udp | udp-lite } ] [ source-port source-port ]
[ destination-port destination-port ] [ verbose ]
display session table ipv4 [ slot slot-number ] [ source-ip
start-source-ip [ end-source-ip ] ] [ destination-ip
start-destination-ip [ end-destination-ip ] ] [ protocol { dccp |
icmp | raw-ip | sctp | tcp | udp | udp-lite } ] [ source-port
source-port ] [ destination-port destination-port ] [ verbose ]
460
Remarks
N/A
By default, the device does not
output session logs.
The device does not output
session logs based on the
packet-based or byte-based
threshold.
N/A
By default, session logging is
disabled.