HP MSR Series Configuration Manual page 331

# Configure the inbound and outbound SPIs for ESP.
[RouterB-ipsec-policy-manual-use1-10] sa spi outbound esp 54321
[RouterB-ipsec-policy-manual-use1-10] sa spi inbound esp 12345
# Configure the inbound and outbound SA keys for ESP.
[RouterB-ipsec-policy-manual-use1-10] sa string-key outbound esp simple gfedcba
[RouterB-ipsec-policy-manual-use1-10] sa string-key inbound esp simple abcdefg
[RouterB-ipsec-policy-manual-use1-10] quit
# Apply the IPsec policy use1 to interface GigabitEthernet 2/0/2.
[RouterB] interface gigabitethernet 2/0/2
[RouterB-GigabitEthernet2/0/2] ipsec policy use1
[RouterB-GigabitEthernet2/0/2] quit
Verifying the configuration
After the configuration is completed, an IPsec tunnel between Router A and Router B is established,
and the traffic between subnet 10.1.1.0/24 and subnet 10.1.2.0/24 is IPsec protected. This example
uses Router A to verify the configuration.
# Use the display ipsec sa command to display IPsec SAs on Router A.
[RouterA] display ipsec sa
-------------------------------
Interface: GigabitEthernet2/0/2
-------------------------------
-----------------------------
IPsec policy: map1
Sequence number: 10
Mode: Manual
-----------------------------
Tunnel id: 549
Encapsulation mode: tunnel
Path MTU: 1443
Tunnel:
local
remote address: 2.2.3.1
Flow:
as defined in ACL 3101
[Inbound ESP SA]
SPI: 54321 (0x0000d431)
Connection ID: 1
Transform set: ESP-ENCRYPT-AES-CBC-128 ESP-AUTH-SHA1
No duration limit for this SA
[Outbound ESP SA]
SPI: 12345 (0x00003039)
Connection ID: 2
Transform set: ESP-ENCRYPT-AES-CBC-128 ESP-AUTH-SHA1
No duration limit for this SA
address: 2.2.2.1
316