Table of Contents
Advertisement
Error correction
Error message
110
Housing open
111
EAN.UCC code
112
Print carriage
113
Applicator error
114
Left position
115
Right position
116
Print position
117
XML parameter
118
Invalid variable
119
No ribbon
120
Wrong directory
121
No label found
122
IP occupied
40
Cause
When starting the print order
the housing cover is not closed.
Transferred EAN.UCC code is
invalid.
Printing carriage does not
move.
Error while using applicator.
Left final position switch is not
in correct position.
Right final position switch is not
in correct position.
The print position is not correct.
The parameters in the XML file
are not correct.
Transferred variable is invalid
with customized entry.
During the print order the
ribbon roll becomes empty.
Defect at the transfer ribbon
photocell.
Invalid target directory when
copying.
No label found at the rear
printhead (DuoPrint).
Soiled label photocell.
Labels not inserted correctly.
The IP address was already
assigned.
Service instructions
Dynacode series
Remedy
Close the housing cover and
start the print order anew.
Verify bar code data (see
corresponding specification).
Check gear belt (possibly
broken).
Check applicator.
Check LEFT final position
switch for correct function and
position.
Check function of pneumatics
for cross traverse.
Check RIGHT final position
switch for correct function and
position.
Check function of pneumatics
for cross traverse.
Check TOP and RIGHT final
position switch for correct
function and position.
Check pneumatics for function
Please contact your
responsible distributor.
Select correct variable without
customized entry and transfer
it.
Change transfer ribbon.
Check transfer ribbon photocell
(service functions).
Target directory must not be
within the source directory.
Check target directory.
Insert new label roll.
Clean the label photocell.
Check if labels are inserted
correctly.
Assign a new IP address.
0808
Advertisement
Table of Contents
