Basic Network Settings - Yealink SIP-T42G User Manual

User Guide for the SIP-T42G IP Phone
The phone status is displayed on the first page of the web user interface.
If IP mode of the phone is configured as IPv4 & IPv6, you can enter either of them in the
Note
browser's address bar to view the phone status. IPv6 is not available on all servers. Contact your
system administrator for more information.

Basic Network Settings

If your phone cannot contact a DHCP server for any reason, you need to configure network
settings manually. The IP phone can support either or both IPv4 and IPv6 addresses.
To configure the IP address mode via phone user interface:
Press Menu->Settings->Advanced Settings (default password: admin)
1.
->Network->WAN Port.
Press
2.
Mode field.
Press the Save soft key to accept the change or the Back soft key to cancel.
3.
You can configure a static IPv4 address for the IP phone. Before configuring it, make sure that
the IP mode is configured as IPv4 or IPv4 & IPv6.
To configure a static IPv4 address via phone user interface:
Press Menu->Settings->Advanced Settings (default password: admin)
1.
->Network->WAN Port.
Press
2.
18
or , or the Switch soft key to select IPv4, IPv6 or IPv4 & IPv6 from the IP
to select IPv4 and then press the Enter soft key.