Message Waiting Indicator (Mwi) - Yealink SIP-T42G User Manual

To configure voice mail access codes via phone user interface:
Press Menu->Message->Voice Mail->Set Voice Mail Code.
1.
Press the navigation keys to highlight the account which you want to set.
2.
Press the 123 soft key to select the proper input mode and then enter the voice mail access
3.
code (e.g., *4).
Press the Save soft key to accept the change or the Back soft key to cancel.
4.
Note Voice mail access codes must be predefined on the system server. Contact your system
administrator for the more information.
To listen to voice mails:
When the LCD screen prompts that the phone receives a new voice mail and the power
1.
indicator LED slowly flashes red, you can press
voice mail access code.
Follow the voice prompt to listen to your voice mails.
2.
Before listening to voice mails, make sure the voice mail access code has been configured.
Note
When all new voice mails are retrieved, the power indicator LED will go out.
To view the voice mail via phone user interface:
Press Menu->Message->Voice Mail->View Voice Mail.
1.
The LCD screen displays the amount of new and old voice mails.
Select an account and then press the Connect soft key to listen to voice mails.
2.

Message Waiting Indicator (MWI)

The SIP-T42G IP phone supports MWI feature when receiving a new voice message. If someone
leaves you a voice mail, you will receive a message waiting indicator. MWI will be indicated in
three ways: a warning tone, an indicator message (including a voice mail icon) on the LCD screen,
and the power indicator LED slowly flashes red. This will be cleared when you retrieve all voice
Advanced Phone Features
or the Connect soft key to dial out the
163