Yealink SIP-T42G User Manual page 138

User Guide for the SIP-T42G IP Phone
monitored user by pressing the BLF key. The phone handles the active call differently depending
on the transfer mode on DSS key (refer to
mode on DSS key has the following modes:
Blind Transfer

Attended Transfer

New Call

When the transfer mode on DSS key is set to Blind Transfer and there is already an active call
on the IP phone, you can do the following:
To perform a blind transfer:
Press the BLF key of the monitored user which you want to transfer this call to.
1.
Then the active call is connected to the number of the monitored user.
When the transfer mode on DSS key is set to Attended Transfer and there is already an active
call on the IP phone, you can do the following:
To perform a semi-attended transfer:
Press the BLF key of the monitored user which you want to transfer this call to. The phone
1.
will dial the number of the monitored user.
Press the BLF key of the monitored user again or the Tran soft key to complete the transfer
2.
when receiving ringback.
To perform an attended transfer:
Press the BLF key of the monitored user which you want to transfer this call to. The phone
1.
will dial the number of the monitored user.
Press the BLF key of the monitored user again or the Tran soft key to complete the transfer
2.
after the monitored user answers the call.
When the transfer mode on DSS key is set to New Call and there is already an active call on the
IP phone, you can do the following:
To perform a new call:
Press the BLF key of the monitored user you want to call.
1.
The phone will dial the number of the monitored user.
Picking up an Incoming Call of the Monitored User
When the monitored user receives an incoming call, the BLF key indicator of the monitored user
will flash red. If you enable visual and audio alert features on the phone, the phone will play a
specific ring tone (refer to
screen. You can use the BLF key to pick up an incoming call of the monitored user. Before
picking up an incoming call, ensure that the directed call pickup code has been configured in
advance.
124
Configuring Transfer Mode on DSS
BLF Ring Type) and display the incoming call information on the
Key). The transfer