Control Panel And I/O Module; Removing The Control-Panel Board - Dell PowerEdge R530 Owner's Manual
Hide thumbs
Also See for PowerEdge R530:
- Getting started (2 pages) ,
- Owner's manual (182 pages) ,
- Getting started (2 pages)
Table of Contents
Advertisement
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
1.
Use the hooks on the chassis as guides to align the hard-drive backplane.
2.
Lower the hard-drive backplane until the release tabs snap into place.
3.
Connect the SAS/SATA/SSD data, signal, and power cable(s) to the backplane.
Next steps
1.
Install all SAS/SATA/SSD hard drives in their original locations.
2.
Reconnect the data, signal and power cables to the backplane.
3.
Follow the procedure listed in
Related Links
Removing a hot-swap hard drive
Installing a hot-swap hard drive
Control panel and I/O module
Removing the control-panel board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure that the
locking tab on the connector is released before removal and insertion. The locking tab must be
engaged after insertion.
NOTE: To prevent damage to the LCD display module cable, do not bend the control panel flex
cable after it is inserted into the connector.
1.
Ensure that you read the
2.
Follow the procedure listed in
3.
Keep the #2 Phillips screwdriver ready.
Steps
1.
Disconnect the USB cable, control panel cable, and the LCD display module cable from the control-
panel board.
2.
Using a #2 Phillips screwdriver, remove the two screws that secure the control-panel board to the
chassis.
3.
Slide the control-panel board toward the back and lift it out of the system.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
117
Advertisement
Table of Contents
Troubleshooting
