Removing The Power Distribution Board - Dell PowerEdge T630 Owner's Manual

Figure 113. Removing the power interposer board
1. power interposer board
3. power distribution board
Related Links
Safety instructions
Before working inside your system
Removing the system board
Installing the power interposer board

Removing the power distribution board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the safety instructions section.
2. Keep the #2 Phillips screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
CAUTION: To prevent damage to the power interposer board (PIB), you must remove the
power supply module(s) from the system before removing the power interposer board or
power distribution board (PDB).
4. Disconnect the power supply module(s) from the back of the chassis.
5. Remove the PCIe card holders.
6. Remove the cooling shroud.
7. If applicable, remove the cooling fan assembly.
2. release pin
197