Power Distribution Boards; Removing A Power Distribution Board - Dell PowerEdge C6320 Owner's Manual

Power distribution boards

Removing a power distribution Board

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This system has two power distribution boards. The procedure to remove and install both
the power distribution boards is similar. To access the power distribution board 2 at the bottom,
remove the power distribution board at the top.
1. It is recommended to turn off the system, including any attached peripherals, and disconnect the
system from its electrical outlet.
2. Open the system.
3. Remove the power supply unit.
4. Disconnect all the cables from the power distribution board 1.
Note the routing of the cable on the chassis as you remove them from the system. You must route
these cables properly when you replace them to prevent the cables from being pinched or crimped.
5. Remove the screw that secures the power cable cover to the power distribution board 1.
6. Lift it up straight from the locking hole on the power distribution board 1. Then, lift it completely out
of the power distribution board 1.
Figure 63. Removing and installing the power cable cover
1. screw
7. Remove the four screws that secure the power cables to the power distribution board 1.
94
2. power cable cover