Installing a mezzanine card
Prerequisite
NOTE:
The procedure to install the mezzanine blank is similar to the removal of a mezzanine card.
1
Follow the safety guidelines listed in
Steps
1
Attach and secure the mezzanine card bracket to the mezzanine card.
2
Holding the card by its edges, position the card so that the card edge connector aligns with the connector of the bridge board on the
system board.
3
Insert the card edge connector and push the card firmly until the card is fully seated on the bridge board.
4
Using the Phillips #2 screwdriver, secure the mezzanine card and bracket assembly to the sled using screws.
108
Installing and removing system components
Safety
instructions.