Table of Contents
Advertisement
HEWLETFPACKARD
MODEL 9825A
Use the following program to send a command
string to the Model 199 from a Hewlett-Packard
Model 9825A and display the instrument
reading string on the computer printer. The computer
must be equipped
with the HF'98034A HPIB Interface
and a 9872A extended I/O ROM.
DIRECTIONS
1. From the front panel, set the primary
address of the Model 199 to 26.
2. With the power off, connect the Model 199 to the 98034A HPIB interface installed iii the 9825A.
3. Enter the lines in the program below, using the STORE key after each line. Line numbers are
automatically
assigned
by the 9fJ?A.
4. Press the 9825A RUN key and type in the desired command
string at the command
prompt.
For example, to place the instnunent
in ACV and autorange, typein FlROX and press the CONT
key.
5. The instrument
reading string will then appear on the computer print out. A typical display
is: NACV+O.KZOOOE+O.
PROGRAM
COMMENTS
Dimension
data strings.
Define 199 at address 26.
Place 199 in remote.
Prompt for command
string.
Address
199 to listen, send string.
Address
199 to talk, input data.
Print data string on printer.
Repeat.
NOTE: For conversion
to numeric
variable, modify the program as follows:
B-7
Hide quick links:
Advertisement
Table of Contents
