Table of Contents
Advertisement
APPENDIX B
HEWLETT-PACKARD
SERIES 200 and 300
The following program sends a corm-iiaiid string to the Model 199 from a Hewlett-Packard
Series
7.00 or 300 &nputtir
atid displays the instrument
reading string on the computer CRT. The com-
puter must be equipped
with the HPIB Interface
and BASIC 2.0, 3.0, or 4.0.
DIRECTIONS
1. From the front panel, set the primary address
of the Model 199 to 26.
2. With the power off, connect the Model 199 to the HPIB interface
installed in the computer.
3. Enter the computer
EDIT mode.
4. Enter the lines in the program below, using the ENTER key after each line.
5. Run the program, and type in the desired command string at the command prompt. Fur emn-
pie, to place the instrument
in AC%' and autorange,
type in FIROX and press the ENTER key.
6. The
inshument
reading
string
will
then
appear
on
the
CRT.
A typical
&play
is:
NACV+O.OOOCUOE+O.
Place 199 in remote.
Prompt for and input command.
Address
199 to listen, send string.
Address
199 to talk, input reading.
Display reading
string.
Repeat.
NOTE: For conversicd
to a ~iiuin&i? variable,
change the program as follows:
B-6
Hide quick links:
Advertisement
Table of Contents
