gefran ADV20 series Quick Start-Up page 44

Parameter Explanation
Source of First
02.01 Operation
Command
02.02 Stop Method
PWM Carrier
02.03 Frequency
Selections
Motor Direction
02.04
Control
02.05 Line Start Lockout
Loss of ACI Signal
02.06
(4-20mA)
02.07 Up/Down Mode
Accel/Decel Rate of
Change of
02.08 UP/DOWN
Operation with
Constant Speed
Source of Second
02.09 Frequency
Command
12 ADV20 QS, V1.02
Settings
0: Digital keypad
1: External terminals. Keypad STOP/RESET
enabled.
2: External terminals. Keypad STOP/RESET
disabled.
3: RS-485 (RJ-45) communication. Keypad
STOP/RESET enabled.
4: RS-485 (RJ-45) communication. Keypad
STOP/RESET disabled.
0: STOP: ramp to stop; E.F.: coast to stop
1: STOP: coast to stop; E.F.: coast to stop
2: STOP: ramp to stop; E.F.: ramp to stop
3: STOP: coast to stop; E.F.: ramp to stop
2 to 12kHz
0: Enable forward/reverse operation
1: Disable reverse operation
2: Disabled forward operation
0: Disable. Operation status is not changed
even if operation command source Pr.02.01
is changed.
1: Enable. Operation status is not changed
even if operation command source Pr.02.01
is changed.
2: Disable. Operation status will change if
operation command source Pr.02.01 is
changed.
3: Enable. Operation status will change if
operation command source Pr.02.01 is
changed.
0: Decelerate to 0 Hz
1: Coast to stop and display "AErr"
2: Continue operation by last frequency
command
0: by UP/DOWN Key
1: Based on accel/decel time
2: Constant speed (Pr.02.08)
3: Pulse input unit (Pr.02.08)
0.01~10.00 Hz
0: Digital keypad UP/DOWN keys or Multi-
function Inputs UP/DOWN. Last used
frequency saved.
1: 0 to +10V from AVI
2: 4 to 20mA from ACI
3: RS-485 (RJ-45) communication
4: Digital keypad potentiometer
Factory
Setting
1
0
8
0
1
1
0
0.01
0
Italiano English
NOTE