D-Link xStack DES-3526 Cli Manual page 51

DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
show config
Parameters
Restrictions
Example usage:
To view the current configuration settings:
DES-3526:4#show config current_config
Command: show config current_config
#-------------------------------------------------------------------
#
#
#
#
#-------------------------------------------------------------------
# BASIC
config serial_port baud_rate 9600 auto_logout 10_minutes
enable telnet 23
enable web 80
# STORM
config traffic control 1-5 broadcast disable multicast disable dlf
disable thres
hold 128
# GM
config sim candidate
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
1. Basic (serial port, Telnet and
web management status)
2. storm control
3. IP group management
4. syslog
5. QoS
6. port mirroring
7. traffic segmentation
8. port
9. port lock
10. 8021x
11. SNMPv3
12. management (SNMP traps
RMON)
current_config – Entering this parameter will display configurations entered without
being saved to NVRAM.
config_in_NVRAM - Entering this parameter will display configurations entered and
saved to NVRAM.
None.
DES-3526 Configuration
Firmware: Build 3.01-B121
Copyright(C) 2000-2004 D-Link Corporation. All rights reserved.
13. vlan
14. FDB (forwarding data base)
15. MAC address table notification
16. STP
17. SSH
18. SSL
19. ACL
20. SNTP
21. IP route
22. LACP
23. ARP
24. IP
25. IGMP snooping
26. access authentication control
(TACACS etc.)
48