D-Link xStack DES-3526 Cli Manual page 187

DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
create authen server_host
Restrictions
Example usage:
To create a TACACS+ authentication server host, with port number 1234, a timeout value of 10 seconds and a retransmit
count of 5.
DES-3526:4#create authen server_host 10.1.1.121 protocol tacacs+ port
1234 timeout 10 retransmit 5
Command: create authen server_host 10.1.1.121 protocol tacacs+ port
1234 timeout 10 retransmit 5
Success.
DES-3526:4#
config authen server_host
Purpose
Syntax
Description
Parameters
xtacacs - Enter this parameter if the server host utilizes the
XTACACS protocol.
tacacs+ - Enter this parameter if the server host utilizes the
TACACS+ protocol.
radius - Enter this parameter if the server host utilizes the
RADIUS protocol.
port <int 1-65535> - Enter a number between 1 and 65535 to define the
virtual port number of the authentication protocol on a server host. The
default port number is 49 for TACACS/XTACACS/TACACS+ servers and
1812 and 1813 for RADIUS servers but the user may set a unique port
number for higher security.
key <key_string 254> - Authentication key to be shared with a configured
TACACS+ or RADIUS server only. Specify an alphanumeric string up to
254 characters.
timeout <int 1-255> - Enter the time in seconds the Switch will wait for the
server host to reply to an authentication request. The default value is 5
seconds.
retransmit <int 1-255> - Enter the value in the retransmit field to change
how many times the device will resend an authentication request when
the server does not respond.
Only administrator-level users can issue this command.
Used to configure a user-defined authentication server host.
create authen server_host <ipaddr> protocol [tacacs | xtacacs
| tacacs+ | radius] {port <int 1-65535> | key [<key_string 254> |
none] | timeout <int 1-255> | retransmit < 1-255>}
This command will configure a user-defined authentication server
host for the TACACS/XTACACS/TACACS+/RADIUS security
protocols on the Switch. When a user attempts to access the
Switch with the authentication protocol enabled, the Switch will
send authentication packets to a remote
TACACS/XTACACS/TACACS+/RADIUS server host on a remote
host. The TACACS/XTACACS/TACACS+/RADIUS server host will
then verify or deny the request and return the appropriate message
to the Switch. More than one authentication protocol can be run on
the same physical server host but, remember that
TACACS/XTACACS/TACACS+/RADIUS are separate entities and
are not compatible with each other. The maximum supported
number of server hosts is 16.
server_host <ipaddr> - The IP address of the remote server host
the user wishes to alter.
184