D-Link xStack DES-3526 Cli Manual page 129

DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
create igmp_snooping multicast_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a multicast VLAN.
DES-3526:4#create igmp_snooping multicast_vlan trinity 2
Command: create igmp_snooping multicast_vlan trinity 2
Success.
DES-3526:4#
config igmp_snooping multicast_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure a multicast VLAN.
Used to create a multicast VLAN on the switch.
create igmp_snooping multicast_vlan <vlan_name 32> <vlanid
2-4094>
This command will create a multicast VLAN on the switch.
<vlan_name 32> − The name of the VLAN for which to create an
IGMP snooping multicast VLAN.
<vlanid 2-4094> - Enter an integer between 2 and 4094 to define the
ID for this multicast VLAN.
You must have administrator privileges.
Used to configure a multicast VLAN previously created on the
switch.
config igmp_snooping multicast_vlan {<vlan_name 32>}
{member_port <portlist> | source_port <portlist> | state [enable
| disable]}
This command will configure a multicast VLAN previously created on
the switch.
<vlan_name 32> − The name of the VLAN for which to configure an
IGMP snooping multicast VLAN.
member port <portlist> - A port or range of member ports to add to
the multicast VLAN. These ports will receive multicast traffic from the
source port. Remember, the source port cannot be the same as any
member port.
source port <portlist> - Enter a port on the Switch to be designated
as the source port for multicast traffic. Multicast traffic entering the
switch will be forwarded from this port to member ports on the same
VLAN. Note that the source port must be different from the member
ports of the created VLAN.
state [enable | disable] – Choose to enable or disable the running
state of this multicast VLAN.
You must have administrator privileges.
126