D-Link xStack DES-3526 Cli Manual page 49

DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
DES-3526:4#download configuration 10.48.74.121 c:\cfg\setting.txt
Command: download configuration 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
DES-3526:4#
DES-3526:4##-------------------------------------------------------------------
DES-3526:4##
DES-3526:4##
DES-3526:4##
DES-3526:4##
DES-3526:4##-------------------------------------------------------------------
DES-3526:4#
DES-3526:4#
DES-3526:4## BASIC
DES-3526:4#
DES-3526:4#config serial_port baud_rate 9600 auto_logout 10_minutes
Command: config serial_port baud_rate 9600 auto_logout 10_minutes
The download configuration command will initiate the loading of the various settings in the order listed in the configuration file.
When the file has been successfully loaded the message "End of configuration file for DES-3526" appears followed by the
command prompt.
DES-3526:4#disable authen_policy
Command: disable authen_policy
Success.
DES-3526:4#
DES-3526:4##-------------------------------------------------------------------
DES-3526:4##
DES-3526:4##-------------------------------------------------------------------
DES-3526:4#
config firmware
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DES-3526 Configuration
Firmware: Build 3.06-B02
Copyright(C) 2000-2004 D-Link Corporation. All rights reserved.
End of configuration file for DES-3526
Used to configure the firmware section as a boot up section, or to
delete the firmware section
config firmware image_id <int 1-2> [delete | boot_up]
This command is used to configure the firmware section. The user
may choose to remove the firmware section or use it as a boot up
section.
image_id – Specifies the working section. The Switch can hold two
firmware versions for the user to select from, which are specified by
image ID.
delete – Entering this parameter will delete the specified firmware
section.
boot_up – Entering this parameter will specify the firmware image ID
as a boot up section.
Only administrator-level users can issue this command.
46