D-Link xStack DES-3526 Cli Manual page 200

DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
config ssh user
Restrictions
Example usage:
To configure the SSH user:
DES-3526:4# config ssh user Trinity authmode Password
Command: config ssh user Trinity authmode Password
Enter a case sensitive new password: *******
Enter the new password again for conformation:*******
Success.
DES-3526:4#
show ssh user
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the SSH user:
DES-3526:4#show ssh user
Command: show ssh user
Current Accounts:
UserName
--------------------------
Trinity
DES-3526:4#
administrator defined password for authentication. Upon entry
of this command, the Switch will prompt the user for a
password, and then to retype the password for confirmation.
publickey – This parameter should be chosen if the user
•
wishes to use the publickey on a SSH server for
authentication.
Only administrator-level users can issue this command.
Used to display the SSH user setting.
show ssh user
This command allows you to display the current SSH user setting.
None.
None.
Authentication
--------------------------
Publickey
Note: To configure the SSH user, the administrator must create a user
account on the Switch. For information concerning configuring a user
account, please see the section of this manual entitled Basic Switch
Commands and then the command, create user account.
197