Multiple Led Pars (Master/Slave Control); Multiple Led Pars (Dmx Control) - SHOWTEC led par 56 short pro rgb User Manual

Multiple LED Pars (Master/Slave
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Always use a safety cable (ordercode 70140 / 70141).
3. Use a 3-p XLR cable to connect the LED Par 56 Short Pro.
The pins:
4. Link the units as shown in (Fig. 4), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page
master device you can set your desired operation Mode and all slave devices will react the same as
the master device.

Multiple LED Pars (DMX Control)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Always use a safety cable (ordercode 70140 / 70141).
3. Use a 3-p XLR cable to connect the LED Pars and other devices.
control)
1. Earth
2. Signal -
3. Signal +
Multiple LED Pars (Master/Slave control)
8
12. This means on the
Fig. 4