Set Up And Operation; Control Modes; One Led Par 56 Short Pro (Static Color Mode); One Led Par 56 Short Pro (Color Jump Mode) - SHOWTEC led par 56 short pro rgb User Manual

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Damages caused by non-observance are not subject to warranty.

Control Modes

There are 7 modes for using the LED Par 56 Short Pro:
One LED Par 56 Short Pro
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Always use a safety cable (ordercode 70140 / 70141).
3. Plug the end of the electric mains power cord into a proper electric power supply socket.
4. When the LED Par 56 Short Pro is not connected by a DMX-cable, it functions as a stand-alone
device. If device is set to
manually controlled.
One LED Par 56 Short Pro
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Always use a safety cable (ordercode 70140 / 70141).
3. Plug the end of the electric mains power cord into a proper electric power supply socket.
4. When the LED Par 56 Short Pro is not connected by a DMX-cable, it functions as a stand-alone
device. If device is set to
manually controlled.
One LED Par 56 Short Pro
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Always use a safety cable (ordercode 70140 / 70141).
3. Plug the end of the electric mains power cord into a proper electric power supply socket.
4. When the LED Par 56 Short Pro is not connected by a DMX-cable, it functions as a stand-alone
device. If device is set to
manually controlled.
One LED Par 56 Short Pro
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Always use a safety cable (ordercode 70140 / 70141).
3. Plug the end of the electric mains power cord into a proper electric power supply socket.
4. When the LED Par 56 Short Pro is not connected by a DMX-cable, it functions as a stand-alone
device. If device is set to
Please see page 12 for more information about the Auto Run Mode.

One LED Par 56 Short Pro (Sound-control)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Always use a safety cable (ordercode 70140 / 70141).
3. Plug the end of the electric mains power cord into a proper electric power supply socket.
4. Turn on the music. If device is set to
the fixture will react to the beat of the music.
Sound control Mode.
(Static Color
Please see page 12 for more information about the Static Color Mode.
(Color Jump
Please see page 12 for more information about the Color Jump Mode.
(Color Dream
Please see page 12 for more information about the Color Dream Mode.
(Auto Run Mode)
and you have pressed enter, then the fixture is manually controlled.
• Static Color Mode
• Color Jump Mode
• Color Dream Mode
• Auto Run Mode
• Sound-controlled
• Master/Slave
• DMX512 (3 or 6 Channels)
Mode)
and you have pressed enter, then the fixture is
Mode)
and you have pressed enter, then the fixture is
Mode)
and you have pressed enter, then the fixture is
(Audio) and you have pressed enter, then
Please see page 12 for more information about the
7