Table of Contents
Advertisement
Power Spot 3 Q5
Control Modes
There are 6 modes:
One Power Spot (Built-in programs, Auto Mode and Manual Mode)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Power Spot is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 14 and 15 for more information about the Built-in programs, Auto Mode and
Manual Mode.
One Power Spot (Sound-controlled)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Turn on the music. If the device is set to sound-control, then the Power Spot will react to the beat of
the music. Please see page 15 for more information about the sound-control options.
Multiple Power Spots (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Power Spot.
The pins:
03) Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 14-15 (Built-in
programs, Auto Mode, Manual Mode or Sound-controlled Mode). This means that you can set your
desired operation mode on the master device and all slave devices will react the same as the
master device.
Multiple Power Spots (Master/Slave control)
Ordercode: 42573
• Built-in programs
• Auto Mode
• Manual Mode (Static Color)
• Sound-controlled
• Master/Slave
• DMX-512 (5CH, 7CH, 9CH)
01)
Earth
02)
Signal -
03)
Signal +
9
Fig. 03
Advertisement
Table of Contents
