Table of Contents
Advertisement
Galactic RGB 720
Control Modes
There are 5 modes:
One Galactic ILD SD Card (visual laser show)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Please see pages 19-22 for more information about the ILD Mode.
One Galactic Built-in (visual laser show)
05) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
06) Always use a safety cable (ordercode 70140 / 70141).
07) Plug the end of the electric mains power cord into a proper electric power supply socket.
08) When the Galactic is not connected with a DMX-cable, it functions as a stand-alone device.
09) Please see page 22 for more information about the Built-in visual effects.
One Galactic Sound-controlled
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Galactic is not connected by a DMX-cable, it functions as a stand-alone device.
05) Please see page 23 for more information about the about the Sound-controlled mode.
Multiple Galactics (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 3-p XLR cable to connect the Galactic.
The pins:
05) Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on pages 22-23 (Built-in or Sound Active).
This means that you can set your desired operation on the master device and all the slave devices
will react copy the behaviour of the master.
Multiple Galactics
(Master/Slave control)
Ordercode: 51340
ILD SD Card
Built-in visual effects
Sound-controlled
Master/Slave
DMX-512
1. Earth
2. Signal (-)
3. Signal (+)
12
Fig. 03
Advertisement
Table of Contents
