Control Modes; One Compact Par (Built-In Programs); One Compact Par (Manual Control); One Compact Par (Pre-Programmed Colors) - SHOWTEC Compact Par 36 CW Instructions Manual

Control Modes

There are 5 modes:
One Compact Par
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. When the Compact Par is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 12 for more information about the built-in programs
One Compact Par
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. When the Compact Par is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 12 for more information about the manual control.
One Compact Par
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. When the Compact Par is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 12 for more information about the Pre-programmed colors.
Multiple Compact Pars
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the Compact Par 36.
The pins:
3. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page 12 (Built-in Programs, or
Manual control). This means on the master device you can set your desired operation Mode and all
slave devices will react the same as the master device.
• Select built-in programs
• Manual control
• Pre-programmed Colors
• Master/Slave
• DMX512
(Built-in Programs)
(Manual Control)
(Pre-programmed
(Master/Slave control)
1. Earth
2. Signal -
3. Signal +

Multiple Compact Pars (Master/Slave control)

Colors)
8
Fig. 3