Control Modes; One Compact Par 7X Cw/Ww (Auto Run Mode And Built-In Programs); Multiple Compact Pars 7X Cw/Ww (Master/Slave Control) - SHOWTEC Compact Par 7x CW/WW V1 Manual

Compact Par 7x CW/WW

Control Modes

There are 4 modes:

One Compact Par 7x CW/WW (Auto Run Mode and Built-in programs)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Compact Par is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 14 for more information about Auto Run Mode, the Built-in programs and Static
Color Mode.

Multiple Compact Pars 7x CW/WW (Master/Slave control)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-p XLR cable to connect the Compact Par and other devices.
The pins:
04) Link the units as shown in Fig. 03, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on pages 14 (Auto run, Built-in Programs).
This means you can set your desired operation mode on the master device and all slave devices will
react the same as the master device.
Multiple Compact Pars 7x CW/WW (Master/Slave control)
Ordercode: 42581
● Auto run
● Built-in programs
● Master/slave
● DMX-512 (2CH or 4CH)
1. Earth
2. Signal (-)
3. Signal (+)
9
Fig. 03