Multiple Performers (Master/Slave Control) - SHOWTEC Performer Profile 600 Q4 Manual

Performer Profile 600 Q4

Multiple Performers (Master/Slave control)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Performer.
The pins:
04) Link the units as shown in fig. 12. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 22 and 23 (Static
Mode, Built-in Programs). This means that you can set your desired operation mode on the master
device and all slave devices will react the same as the master device.
Multiple Performers (Master/Slave control)
Ordercode: 33061
01) Earth
02) Signal -
03) Signal +
16
Fig. 12