8.3
Implementing more additional functions in the signal flow
The pre-assignment of the application can be reconfigured via configuration parameters.
Thus, additional functions can be implemented in the signal flow as well.
Please observe the "source/destination principle" in this connection:
A device input terminal can be linked to several input interfaces of the application.
Each input interface of the application can only be linked to one input signal.
An output interface of the application can be linked to several device output terminals.
The following subchapter
detail the configuration parameters for the "actuating drive speed" application.
from Firmware V06.00 - DMS 1.1 EN - 11/2011
8400 StateLine C | Operating instructions
Implementing more additional functions in the signal flow
"Pre-assignment of the input and output
L
Adapting the application individually
interfaces" shows in
63