LAP timer
This function lets you display lap times.
To enable this function, enter the menu and set the
LAP function to "On" by holding RESET button (14,
fig. 5) pressed for 3 seconds.
The lap timer is started and stopped using the high-
beam flasher button FLASH (13, fig. 5) on the LH
switch.
When the LAP function is active, each time you press
the FLASH button, the instrument panel will display
press RESET for 3 sec.
the lap time for 10 seconds, before reverting to
normal mode.
Up to 30 lap times can be stored.
If the memory is full, each time you press the FLASH
button, no more lap times can be saved and the
instrument panel will display the flashing message
"FULL" for 3 seconds until the memory is reset.
press RESET for 3 sec.
fig. 22
39