Handling The "Recalibrate The Scanner" Message - Scantronic iNSIGHT 20 Plus Operator's Manual

Chapter 3: Installation

Handling the "Recalibrate the scanner" Message

Handling the "Recalibrate the scanner" Message

72
Scantron normally recommends calibrating the scanner
only upon initial setup or under the guidance of a
Scantron Customer Support Representative. However,
there are certain situations where you may get an error
message similar to the one below recommending that you
recalibrate the scanner.
The possible causes of this error message are:
• If calibration was unsuccessful.
• If you aborted the installation procedure before
calibration was completed.
• If you moved the scanner to a new host computer.
• If you swapped out a defective scanner for a new one.
If one of these conditions applies to you, you will need to
recalibrate the scanner. See "Step 1: Calibrating Your
iNSIGHT 20 Plus" on page 57, and follow the procedure
there to recalibrate the scanner.
i
Scantron NSIGHT 20 Plus Scanner