Scantronic iNSIGHT 20 Plus Operator's Manual page 115

Chapter 5: Maintenance
102
• Some debris from the foam tires on the feed and
separation modules is normal. Tire debris does not
always mean that the tires are worn or damaged. After
cleaning, inspect the tires for wear and replace the
separation module or feed module if necessary.
• When cleaning rollers, use an emulsiclean wipe and
allow the rollers to dry completely before scanning.
• When cleaning tires, use a slightly damp staticide wipe
and allow the tires to dry completely before scanning.
• In addition to the recommended cleaning supplies,
you may use a vacuum cleaner to remove debris from
the scanner.
• If a difficulty persists after performing the
maintenance recommended in this manual, call
Scantron Customer Support as described in
"Requesting Support" on page 153.
i
Scantron NSIGHT 20 Plus Scanner