Lamps - Scantronic iNSIGHT 20 Plus Operator's Manual

Chapter 6: Troubleshooting

Lamps

Lamps

Software
• ScanTools Plus
• associated data collec-
tion diagnostic software
Click&Scan
140
Lamp warm up and shut off periods vary depending on
the software that you are using. See the table below:
Warm up
N/A
10 seconds
NOTES:
• The scanner changes to low power mode after 15
minutes of inactivity.
• If you want to shut off the lamps sooner than 240
minutes after running a ScanTools Plus application,
simply run Click&Scan with the Power Saver Device
Setting set to the desired shut off time.
Shut off
240 minutes
0 to 240 minutes based
on Power Saver setting
in Device Settings
i
Scantron NSIGHT 20 Plus Scanner