Replacing The Pre-Separation Pad - Scantronic iNSIGHT 20 Plus Operator's Manual

Chapter 5: Maintenance

Replacing the Pre-Separation Pad

Replacing the Pre-Separation Pad

122
1.
Remove and inspect the separation module as
described in steps 1 through 2 of "Removing and
Replacing the Separation Module" on page 119.
2.
Hold the separation module in both hands and find
the two side tabs that protrude slightly from the back
of the separation module.
3.
Push on the side tabs until the pre-separation pad
protrudes slightly from the front of the separation
module.
Tabs
i
Scantron NSIGHT 20 Plus Scanner