Scantronic iNSIGHT 20 Plus Operator's Manual page 72

Operator's Guide
If you have completed the iNSIGHT Scanner
NOTE:
Utilities installation, open the Calibration Utility from
your operating system
The following dialog box appears.
3.
Click Calibrate. The Step 1 of 2 dialog box appears.
4.
Place a stack of Normalization & Calibration Sheets
(part number 202 502 043) into the input tray, printed
side down, so that the words "Normalization &
Calibration Sheet" enter the scanner first, as shown in
the graphic below.
The corner is turned in the image below to show
NOTE:
the printed side.
Chapter 3: Installation
Getting Ready to Scan
59