Maintenance Schedule - Scantronic iNSIGHT 20 Plus Operator's Manual

Maintenance Schedule

Procedure
Clean separation
module tires
Clean feed module tires
Clean drive rollers and
transport area
Clean imaging guides
Operator's Guide
Use the following table as a guide to routine maintenance.
Usage figures are not guaranteed. Customer-operating
environments, document type, the condition of
documents being scanned, and not following the
recommended cleaning and replacement procedures, can
cause the life of the consumables to vary.
Interval
As required
depending on the
type of scanning
being performed.
As required
depending on the
type of scanning
being performed.
As required
depending on the
type of scanning
being performed.
Daily
Chapter 5: Maintenance
What to Use
Use staticide wipe (part number
ACL305) -- slightly damp. Allow
to air dry before scanning.
Use staticide wipe, (part number
ACL305) -- slightly damp. Allow
to air dry before scanning.
Run transport cleaning sheet,
(part number ACL303). If
required, use emulsiclean wipe,
(part number ACL304) on red
and white rollers. Allow to air
dry.
Do not use the
CAUTION:
emulsiclean wipes on
the gray foam tires.
Use staticide wipe, (part number
ACL305) -- slightly damp. Wipe
with a dry staticide wipe before
scanning.

Maintenance Schedule

103